Monthly Archives: May 2019

Extra class!

I earned my Extra class license today!  I took a “cram n’ exam” session sponsored by the Andrew Johnson Amateur Radio Club in Greeneville.  I was sweating bullets when it came to the afternoon as I was afraid I wasn’t … Continue reading

Posted in Uncategorized | 1 Comment

More on the Mosley

I heard back from Mosley about the RV4C.  The base is $24.95 but with $16 shipping and handling.  So it’s going to have to wait for a while before I can get it fixed.  I think this weekend I will … Continue reading

Posted in Uncategorized | Leave a comment

The Mosley RV4C

When we moved to our current home in 2015, I stuck the unassembled Mosley under my ham shack.  I pulled it out today and laid everything out: The antenna is 33 feet tall normally but if you look at the … Continue reading

Posted in Shack Work | Leave a comment

Site survey

So I decided to do a site survey tonight which really means I stood around outside, chin in my hand, for 30 minutes and thought about six different types of antennas I could set up.  I’m still planning on putting … Continue reading

Posted in Shack Work | Leave a comment

Another antenna

I forgot that I have my Mosley RV-4C vertical (10-40 meters and I have the 80 meter coil on it).  The base of the antenna broke off quite some time ago.  I can get a new base for $50 from … Continue reading

Posted in Shack Work | Leave a comment

So far so good

The 40-meter hamstick dipole is doing surprisingly well being it’s close to power lines.  I’m hoping to get a set of 80-meter hamsticks and relocate the antenna further in our property, away from noisy powerlines.  If the finances allow, I’d … Continue reading

Posted in Shack Work | Leave a comment

The shack

I finally took a picture of the “operating position” in my tiny shack.  It’s an 8′ x 10′ room so there’s not much room in it. The 706MKII is sitting on a shelf to the left in this picture.  Seen … Continue reading

Posted in Shack Work | 2 Comments

Configuring the serial port under Linux

I discovered that this new computer has its physical serial port at address Ox3F8 but on IRQ 10.  I wasn’t sure how to correct this problem so I dug deeper.  This is specifically for Slackware Linux but this should apply … Continue reading

Posted in Shack Work | Leave a comment